Briggs & Stratton Sprint 90000 Manual del operador Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 20
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
15
Spark Plug
Use only Briggs & Stratton Spark Tester (part number
19368) to check for spark.
.030” (0.76 mm) WIRE GAUGE
Note: In some areas, local law requires using resistor
spark plug to suppress ignition signals. If this engine
was originally equipped with resistor spark plug, use
same type for replacement.
Combustion Deposits
We recommend that after every 100-300 hours you
have an authorized Briggs & Stratton Service Dealer
remove combustion deposits from the cylinder, cylinder
head, top of piston, and around valves.
Muffler
Replacement parts for the
muffler must be the same
and installed in the same
position as the original
parts, otherwise fire can
occur.
WARNING
Fuel System
Replacement parts for
fuel system (cap, hoses,
tanks, filters, etc.) must
be the same as original
parts, otherwise fire can
occur.
WARNING
Cleaning Debris
Daily or before every use, clean grass, chaff or
accumulated debris from engine. Keep linkage, spring
and controls clean. Keep area around and behind
muffler free of any combustible debris.
Finger Guard
Linkage, Springs
& Controls
Muffler Area & Spark Arrester
CLEAN
ROTATING
SCREEN
FINGER GUARD
CLEAN
CLEAN
Do not use water to clean engine parts. Water
could contaminate fuel system. Use a brush or dry
cloth.
CAUTION
Engine parts should be
kept clean to reduce the
risk of overheating and
ignition of accumulated
debris. This is especially
important if cutting tall
grass.
WARNING
Carburetor Adjustment
The carburetor on this engine is not adjustable.
The manufacturer of the equipment on which
this engine is installed specifies top speed at
which the engine will be operated. DO NOT
EXCEED this speed.
WARNING
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios