Briggs & Stratton 31D707 Instrucciones de operaciones descargar pdf (Pagina 17)

• On Models FRS-30 and FRS-38 you must pull the

handle G (Fig. 10) downwards to set depth of cut and

lock in position by tightening Knob H (Fig. 10).

• Carefully pull handle F (Fig. 10) & G (Fig. 10) to ad-

vance the cutting blade through the material.

• Make the cuts from left to right with the material with

the material up against the backstop on the far right

of the table.

• To tilt the head J (Fig.11) 0°- 45°, loosen the two

side lever handles K (Fig. 11). Adjust to the angle

needed and tighten the lever handles again.

NOTE:

To accurately set 0° tilt, adjust the micrometric screws

L (Fig. 11).

Fig.10

Fig.11

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Sin comentarios

Briggs & Stratton 31D707 Instrucciones de operaciones Pagina 17