Briggs & Stratton Proseries Manual del operador descargar pdf (Pagina 5)

OPERATION

Startup Checklist

Use the following checklist to verify the correct preparation of your engine generator

before starting.

On all units check:

Engine oil-fill as required with correct grade and quantity.

Check fuel level-fill with clean fresh fuel as required.

Visually check unit for loose parts.

Ventilation. (DO NOT operate indoors. Exhaust gases are deadly.)

Starting

Refer to engine operator's manual for the location of the choke. Close the choke

lever completely to start a cold engine. When restarting a warm engine, close the

choke halfway.

NOTE: Avoid overchoking. Don't leave the choke in the closed position after the

engine starts. It may not be necessary to choke the engine when it is warm.

Manual Start: Pull the recoil starter Slightly and when compression is felt, give

the starter rope a sharp, vigorous pull.

DO NOT change engine speed settings..The engine speed has been preset at the

factory for

3600

RPM operation and the governor speed control tightened to prevent

slipping. Operating the engine at a higher or lower speed can result in engine,

generator or other equipment damage.

Operation: It is a good practice to allow the engine to run for

minutes before

applying a load to the generator. This enables the engine to warm up and the oil

to thoroughly circulate throughout the engine.

short warm-up time will permit

the engine to work more efficiently when the load is applied and will reduce the

wear in the engine, extending its life.

1 2 3 4 5 6 7 8

Sin comentarios

Briggs & Stratton Proseries Manual del operador Pagina 5