Briggs & Stratton 252700 Especificaciones descargar pdf (Pagina 15)

STARTER MOTOR CURRENT DRAW

120 VOLT STARTER MOTORS A

Use Line Current Adapter, Tool part number 19358,

when checking current draw on 120 volt starter

motors. Use the same test xture used in the 12

volt starter test to check the current draw and free

running RPM of motor.

The following test procedure must be

used to avoid any accidental shock

hazard to the service technician.

1. Insert BLACK test lead from adapter, Tool part

number 19358, into the

COM

receptacle in

meter.

2. Insert white test lead from adapter, Tool part

number 19358, into the

receptacle in

meter.

3. Plug the adapter cord (female end) into the switch

box receptacle of the starter motor.

4. Plug the adapter cord (male end) into the

previously tested wall outlet.

5. Rotate selector to A

position.

6. Refer to specications, Table 4, and note

maximum allowable amperage draw for motor

being tested.

7. Depress starter switch button. When meter

reading stabilizes, (approximately 3 seconds)

amperage should not exceed the specication

shown in Table 4.

CAUTION: If amperage is higher than

specication in Table 4, immediately

stop the test! An amperage reading

higher than number in chart, indicates

a shorted starter motor, which could be

dangerous.

120 Volt AC Starter Motor Current Draw

with Line Current Adapter

8. If starter motor amperage is within specication,

check RPM using vibration tachometer, Tool part

number 19200.

9. RPM should be close to specications listed in

Table 4.

10. If the starter motor does not meet the given

specications, refer to the Repair Instructions

Manual, Section 7.

TABLE 4

120 VOLT STARTER MOTOR SPECIFICATIONS

STARTER MOTOR

IDENTIFICATION

MAXIMUM

AMPERAGE

MINIMUM

RPM

American Bosch

SME–110–C3

SME–110–C6

SME–110–C8

3.5 7400

American Bosch

06026–28–M030SM

3.0 7400

Mitsubishi

J282188

3.5 7800

Briggs & Stratton

3-1/2˝ (75.45 mm) Motor Housing

2.7 6500

PUSH

SWITCH TO

ACTIVATE

STARTER

TACHOMETER

READ RPM OF

STARTER MOTOR

AC LINE VOLTAGE MUST

BE NO LESS THAN 110 VOLTS

another free manual from www.searstractormanuals.com

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Comentarios a estos manuales

Sin comentarios

Briggs & Stratton 252700 Especificaciones Pagina 15

Comentarios a estos manuales