Briggs & Stratton 252700 Especificaciones descargar pdf (Pagina 9)

DC SHUNT INSTRUCTIONS

The DC shunt, part number 19468 readily adapts

to standard mount, side mount or tab type battery

terminals. The shunt must be installed on the

- (negative) terminal of the battery.

For standard terminals, attach ring terminal on shunt

to post terminal on battery. For tab terminal batteries,

attach shunt to battery terminal using 1/4

" – 20 stud

and wing nut. For side terminal batteries, remove

post terminal from shunt and thread into side terminal

on battery. Attach battery cable to shunt using

3/8" – 16 nut from post terminal.

The Digital Multimeter will withstand DC input of

10 – 20 Amps for up to 30 seconds. To avoid blowing

fuse in meter, use the DC shunt when checking

current draw of 12 volt starter motors or DC output

on 16 Amp regulated alternator.

Charging output can be checked with the engine

running. All connections must be clean and tight for

correct amperage readings.

1. Install shunt on negative battery terminal.

2. Insert RED test lead into v receptacle in

meter and RED receptacle on shunt.

3. Insert BLACK test lead into

COM

receptacle in

meter and BLACK receptacle on shunt.

4. Rotate selector switch to

300mV

position.

Standard Mount Tab Mount Side Mount

NEGATIVE BATTERY

TERMINAL

ATTACH NEGATIVE

BATTERY CABLE

LEAD

NEGATIVE

BATTERY

TERMINAL

NEGATIVE BATTERY

TERMINAL

ATTACH

NEGATIVE

BATTERY

CABLE WITH

3/8"-16 NUT

ATTACH NEGATIVE

BATTERY CABLE

NEGATIVE BATTERY

TERMINAL

another free manual from www.searstractormanuals.com

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Comentarios a estos manuales

Sin comentarios

Briggs & Stratton 252700 Especificaciones Pagina 9

Comentarios a estos manuales